Home › PLA › Polymaker PolyMax PLA
Polymaker PolyMax PLA — print settings
Polymaker's recommended PLA settings, straight from the technical data sheet. src A
Notes
Toughened PLA (higher impact resistance than standard PLA). TDS nozzle 190–230 °C, bed 25–60 °C, print 40–60 mm/s, fan on, retraction 1 mm / 20 mm/s (0.4 mm nozzle reference).
Keep sealed; dry if moisture is suspected.
Source: PolyMax PLA TDS V5.3 (PDF) src A · last verified 2026-06-10. Publishes detailed per-product TDS PDFs. Recommended settings are stated for a 0.4 mm nozzle (Simplify3D reference).
Buy Polymaker PolyMax PLA
Affiliate link. As an Amazon Associate this site may earn from qualifying purchases, at no extra cost to you. This does not affect the settings or data above. Disclosure.
About PLA
The default beginner filament: prints cool, almost no warping, no enclosure needed. Plant-derived. Great detail and easy bed adhesion; the trade-off is low heat resistance (parts soften around 50–60 °C) and brittleness under sustained load — keep finished PLA parts out of hot cars and direct sun.
- Prototypes and visual models
- Toys, figurines, miniatures
- Indoor display pieces
- Anything where heat resistance does not matter
- Car interiors / outdoor sun exposure
- Functional parts under sustained load or heat
- Enclosures around hot electronics
More PLA brands and the full settings table: PLA settings →
FAQ
What temperature should I print Polymaker PolyMax PLA at?
Polymaker recommends a nozzle temperature of 190–230 °C and a bed of 25–60 °C. A good starting point is about 210 °C nozzle / 45 °C bed; tune with a temperature tower. Source: Polymaker (2026-06-10).
Does Polymaker PolyMax PLA need an enclosure?
No. Polymaker PolyMax PLA prints fine on an open-frame printer.
Do I need to dry Polymaker PolyMax PLA?
Keep sealed; dry if moisture is suspected.