SUNLU · PLA spec sheet
SUNLU PLA Meta print settings
SUNLU's recommended PLA settings, from the manufacturer's own published guidance. Every value below carries its source and the date we checked it.
Notes
High-fluidity PLA that flows at lower temps for high-speed printing. SUNLU lists nozzle 185–210 °C, bed 50–65 °C, 50–100 mm/s.
Store sealed; dry if moisture is suspected.
Source: SUNLU PLA Meta guide (official store) srcB · last verified 2026-06-10. High-volume value brand; recommended settings come from SUNLU's official store guides.
Buy SUNLU PLA Meta
Affiliate link. As an Amazon Associate this site may earn from qualifying purchases, at no extra cost to you. This never changes the settings or data above. Disclosure.
About PLA
The default beginner filament: prints cool, almost no warping, no enclosure needed. Plant-derived. Great detail and easy bed adhesion; the trade-off is low heat resistance (parts soften around 50–60 °C) and brittleness under sustained load — keep finished PLA parts out of hot cars and direct sun.
- Prototypes and visual models
- Toys, figurines, miniatures
- Indoor display pieces
- Anything where heat resistance does not matter
- Car interiors / outdoor sun exposure
- Functional parts under sustained load or heat
- Enclosures around hot electronics
More PLA brands and the full settings table: PLA settings →
FAQ
What temperature should I print SUNLU PLA Meta at?
SUNLU recommends a nozzle temperature of 185–210<span class="u">°C</span> and a bed of 50–65<span class="u">°C</span>. A good starting point is about 195 °C nozzle / 55 °C bed; tune with a temperature tower. Source: SUNLU (2026-06-10).
Does SUNLU PLA Meta need an enclosure?
No. SUNLU PLA Meta prints fine on an open-frame printer.
Do I need to dry SUNLU PLA Meta?
Store sealed; dry if moisture is suspected.