HATCHBOX · PLA spec sheet
HATCHBOX PLA print settings
HATCHBOX's recommended PLA settings, from the manufacturer's own published guidance. Every value below carries its source and the date we checked it.
Notes
HATCHBOX states nozzle 180–220 °C and a heated bed is not required; if used, 50–60 °C. They recommend small test prints to dial in per-printer.
Store sealed; dry if moisture is suspected.
Source: HATCHBOX FAQ (recommended ranges) srcB · last verified 2026-06-10. Widely used value brand; publishes recommended ranges on product listings and its FAQ rather than a downloadable TDS.
Buy HATCHBOX PLA
Affiliate link. As an Amazon Associate this site may earn from qualifying purchases, at no extra cost to you. This never changes the settings or data above. Disclosure.
About PLA
The default beginner filament: prints cool, almost no warping, no enclosure needed. Plant-derived. Great detail and easy bed adhesion; the trade-off is low heat resistance (parts soften around 50–60 °C) and brittleness under sustained load — keep finished PLA parts out of hot cars and direct sun.
- Prototypes and visual models
- Toys, figurines, miniatures
- Indoor display pieces
- Anything where heat resistance does not matter
- Car interiors / outdoor sun exposure
- Functional parts under sustained load or heat
- Enclosures around hot electronics
More PLA brands and the full settings table: PLA settings →
FAQ
What temperature should I print HATCHBOX PLA at?
HATCHBOX recommends a nozzle temperature of 180–220<span class="u">°C</span> and a bed of 50–60<span class="u">°C</span>. A good starting point is about 200 °C nozzle / 55 °C bed; tune with a temperature tower. Source: HATCHBOX (2026-06-10).
Does HATCHBOX PLA need an enclosure?
No. HATCHBOX PLA prints fine on an open-frame printer.
Do I need to dry HATCHBOX PLA?
Store sealed; dry if moisture is suspected.